Installing carpeting above a hardwood flooring isn’t a process that is hard, but it will require some physical labor. You spot little holes in the hard-wood by installing a slim tackless strip that grips the outer perimeter of the carpet throughout the perimeter of the area. Whatever you have to do is fill the tiny holes left having a little wood putty that matches the hard-wood flooring in the event that you would like to eliminate the carpeting to expose the hardwood sooner or later.
Sweep the ground to eliminate any particles, using vacuum or a broom.
Reduce and measure tackless strips to fit round the perimeter of the area where you’re planning to to put carpet. Cut these strips using a hand-saw or a pair of heavy duty shears.
Measure the thickness of the carpet. Set the strips parallel in a length that’s two thirds the thickness of the carpet. Point the pins to the strip toward the wall. Butt together the edges of the strips. Secure the strips in place using a masonry nail in the conclusion of every strip.
Therefore it addresses the whole area, such as the strips unroll the padding. In the event the padding has seams, butt the edges together and join them with duct-tape. Cut the edge of the padding although it comes to the strip, but doesn’t protect it, using a utility knife. Place staples 6″ apart across the perimeter to contain the the padding set up.
Place the carpeting in the area, enabling three to four inches of additional carpeting along each wall.
Hook the fringe of of the carpet to the strip pins in one corner. Therefore it faces the wall place the knee kicker. Kick the kneepad of the knee kicker by means of your knee as you spot and elevate the carpet. Run the fringe of of a stair instrument across the most notable of the strip to end pressing the carpeting to the points.
Brace an electric stretcher having an item of scrap carpet under it against-the-wall in the corner where the carpet was set by you. Set the the top of the energy stretcher to the carpeting in the corner. Push the strength stretcher lever down to pull the carpeting. Set the carpet, as you do s O.
In order to pull the carpeting tight the energy stretcher. Stretch the carpeting over the strip.
Move the energy stretcher to one of the corners that are completed. Therefore you’ll be able to stretch the corner of the carpeting in to place, set it.
Work the right path throughout the room with all the knee kicker, setting and lifting the carpet that is stretched .
Use a carpet trimmer to cut-away any excessive carpeting. Run the trimmerâs edge as near the wall as achievable to get a neat, straight-cut.
Push the carpet edges across the fringe of of the wall using a stair instrument. This this product aids disguise any threads that are added plus the carpeting is tucked by it beneath the baseboard.
Install a changeover strip across each threshold to finish the installation.